Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12658 Discussions

Proper method pulling header files into the Software Build Tools *_sw.tcl

Altera_Forum
Honored Contributor II
‎12-13-2012 07:52 PM
1,334 Views

With the legacy tools, header files seemed to get pulled over correctly as long as the directories were properly specified in the SOPC builder. 

 

I'm running into some difficulties getting header files in a custom IP folder included into the NIOS II software build tools BSP folder. I've created a component _sw.tcl with commands I thought would pull in the headers and made sure the version number in the component_hw.tcl matched the component_sw.tcl. 

 

Is there a documented set of steps or example from Altera on how to pull in custom IP header files? Or can someone here please provide me with an example? Thanks.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎12-13-2012 08:56 PM
393 Views

Well it works now after the SBT IDE was restarted and the versions were specified as the Quartus version.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.