- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi I want to interface SDcard or MicroSD to EP2C8Q208.
1. Do I need to drive SD_CLK to PLL_Out pin or I can use any regular I/O on Cyclone 2. I want to use SPI mode so only 4 signals are used, is this schematic correct and is there some other examples of connecting SDcard to Cyclone FPGA. 3. I think also that adding 10K resistor on CLK signal is not best idea. ThanksLink Copied
0 Replies
![](/skins/images/B7BA37F9CE4B52FF7CAE1FB0388839C8/responsive_peak/images/icon_anonymous_message.png)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page