- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using a STREAM FPGA board connected to an RF board.
Up until now, Quartus has been able to output frequencies to the NCO IP. Next, I want to send the output frequency to the transmitter of the RF board and confirm it through the spectrum analyzer. I do not know how to connect the two boards (RF, STREAM). I do not understand why the downloaded user guide uses SPI techniques. I would like to get good advice or related guidance for me.Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page