Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12692 Discussions

Using Epcs for PowerUp and for WR/RD

Altera_Forum
Honored Contributor II
‎07-11-2010 12:19 PM
1,151 Views

Hi, 

Is there any problem Using Epcs for PowerUp ( I am storing the sof and the zimage on my epcs64 ) and for writing and reading Data?  

of-course when using different addresses. 

How to do it? 

 

one more, 

must the Epcs be deleted completly before writing to one address/bank? 

 

Thanks, 

Erez
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎07-11-2010 12:29 PM
467 Views

No, not completely, but the sector that you want to write to must be erased. 

 

See the EPCS handbook to see how big are the sectors and how are the sectors organized.
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎07-12-2010 12:32 AM
467 Views

Please check section 3. on the wiki 

 

http://nioswiki.com/operatingsystems/uclinux/flashprogrammer 

 

- Hippo
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.