Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

different memory size for "Nios II Hardware Development Tutorial"

Altera_Forum
Honored Contributor II
‎11-29-2011 02:05 PM
1,077 Views

Hi, 

 

I follow the "Nios II Hardware Development Tutorial" on Cyclone IV GX development board and it run successfully. 

 

Then i increase the on-chip memory size from 20KB to 64KB, and repeat the tutorial. 

 

But when i run it nothing happen. 

 

This is the last message in console: 

 

 

"Using cable "USB-Blaster [USB-0]", device 1, instance 0x00 

Processor is already paused 

Reading System ID at address 0x00029070: verified 

Initializing CPU cache (if present) 

OK 

 

Downloading 00010000 ( 0%) 

Downloading 00012EB4 (93%) 

Downloaded 12KB in 0.2s (60.0KB/s) 

 

Verifying 00010000 ( 0%) 

Verifying 00012EB4 (93%) 

Verified OK  

Starting processor at address 0x000101B4" 

 

Thanks.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.