problem to start the debug with IDE

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

problem to start the debug with IDE

969 Views

Hi,

i'm trouble to starting the debug from IDE.

Some time the system give me the following error :

"There are two or more Nios II CPUs with debug modules available which match

the values specified. Please use the --device and/or --instance parameters

to pick one (or open the "Run/Run" or "Run/Debug" dialog and go to the

"Target Connection" tab)."

In the project i have just one processor on one device (cyclone) on dedicated jtag port, i was thinking about a problem on jtag port, but is very simple interface and the fpga programming and flash programming with flash programmer tools and custom hw board project are working.

So , does anyone have a suggestion ?

anyone will be appreciated......

http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/tongue.gif

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.