- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Actually, i am new user to NIOSII and Quartus. I was doing Altera tutorials to get used to them and in one of the tutorials, i stucked in the middle and i had this message in the console... using cable "usb-blaster [usb-0]", device 1, instance 0x00pausing target processor: not responding.
resetting and trying again: failed
leaving target processor paused I think that I did all the steps correct and i read a lot of answers for this problem but nothing works.... I guess this is something related to the license..... Does anyone have an idea? Thanks....
Link Copied
6 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Me too :D It seems that u have the same problem????????- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
the problem is that there could be a lot of reasons. Maybe you can describe the system in detail. Which memory is used, which nios, have you made changes in sopc etc.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kamardino,
If you don't have a permanent Nios license and you are using it in Opencore evaluation mode, you should keep the USB Blaster connected to the board, otherwise all non licensed modules would be disabled. If this is your case, simply don't close the programmer message box which appears just after you have configured your fpga. Cris- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cris,
This was exactly my problem beacuse everytime i have a window after programming called "openCore Plus status" and the time remaining within this window is unlimited... so I closed this window.. I would like to thank you for your help- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Don't worry, we all make this mistake at least once ;)
I wished the opencore window was more explicit about what actually happens when you click on "cancel"
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page