Hi everyone
Hopefully someone will be able to help I have managed to get u-boot up and running on a new board and I am testing my EPCS16 but if I enter epcs info I get a negative value as shown below
EPCS16: 2048 kbytes (32 sectors x 64 kbytes, 256 bytes/page)
status: 0x00 (WIP:0, WEL:0, PROT':'off)
config:0xff7e7e7f (-8487297) bytes
0: 000000 data @ 0x000020
1: 010000 data @ 0x010000
2: 020000 data @ 0x020000
3: 030000 data @ 0x030000
4: 040000 data @ 0x040000
5: 050000 data @ 0x050000
6: 060000 data @ 0x060000
7: 070000 erased
8: 080000 erased
9: 090000 erased
To allow u-boot to access the EPCS I have added the following in epcs.c
static struct epcs_devinfo_t devinfo[] = {
{ "EPCS1 ", 0x10, 17, 4, 15, 8, 0x0c },
{ "EPCS4 ", 0x12, 19, 8, 16, 8, 0x1c },
{ "EPCS16", 0x14, 21, 32, 16, 8, 0x1c },
{ 0, 0, 0, 0, 0, 0 }
};
Hopefully someone else has done this, to save me spending hours stepping through the code to see were I have gone wrong
Many thanks :confused:
