Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12652 Discussions

uCLinux SGMII and SFP modules

Altera_Forum
Honored Contributor II
‎07-15-2013 04:01 PM
1,082 Views

Hi All, 

We have a custom Cyclone IV board with an SFP interfaced to the FPGA via SGMII on a standard Altera TSE. We also have an opencores i2c bus to control the moddef pins. 

We have a uClinux build that works with the same PCB but with a standard GMII/MDIO interfaces to a Micrel PHY. This works fine. 

Can anyone give me any assistance in what would be required to set up the drivers etc for SGMII rather than GMII?  

If it helps I am using the device tree for kernel config. 

 

Many thanks 

Vern
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.