- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a document from intel named "Strain Measurement Methodology for Circuit Board Assembly: Guide." In it there is an image referencing three strain gage locations also discussed in this document. There is the POR location, ALT1 location, and ALT2 location. I would like to know what is the difference between these strain gage placement locations in the amount of strain they measure. Do they measure the same amount of strain occuring at the corner of the BGA component? Or, do they measure some slight difference in the amount of strain on the corner of the BGA component?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, JPfeif1:
Please stay with your other thread .
Regards,
![](/skins/images/D2683F18326913BBA0436CB7114DD569/responsive_peak/images/icon_anonymous_message.png)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page