Altera INK w/ Softing EtherCAT ip core

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Altera INK w/ Softing EtherCAT ip core

1,421 Views

Hi!

Has anybody here used Softing's EtherCAT ip core running on Altera's Industrial Networking Kit w/Cyclone IV board (I mean this one: http://industrial.softing.com/uploads/softing_downloads/IE011E2_201307_AccessIP_EtherCAT_01.pdf )?

I'm facing two problems with this solution:

* There is no settings.bsp file within project bsp directory. Obviously, it causes errors when building the demo application. I overcome this solution by creating a blank .bsp file and then generating a new one by BSP Editor in Eclipse, but I doubt whether it is the best solution.

* When adding a new component to the application core and changing code of the demo application, communication with TwinCAT EtherCAT master delivered with the core fails.

Has anybody encountered these problems?

Best regards

Eketh

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.