Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21602 Discussions

Can't write DE1 flash with control panel application

Altera_Forum
Honored Contributor II
‎02-26-2014 10:53 PM
1,140 Views

I am trying to install the Zet 80186 system on a DE1 which requires a BIOS to be flashed at 0x0 and a floppy image at 0x20000. 

I am using Control Panel V2.0.1 

My first attempt completed but the system would not boot from the floppy image. 

I assumed that there must be a problem with the image and attempted to erase and reflash. 

I have reflashed the BIOS several times but every attempt to reflash the floppy image fails immediately. 

The error message is odd, it says "Write to FLASH Fail.[5.5sec]." This seems to imply that the write failed after so many seconds. The precise figure varies but is always greater than the few milliseconds that it actually takes. 

Just above the error message is "Note. Please erase flash before first writing data" 

 

I suspect that the flash chip has died and won't erase but I would like to exhaust the possibilities before sending the board back. 

 

Am I doing something wrong? Is there a simple way to test the flash?
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎02-27-2014 09:18 AM
411 Views

This issue seems to have resolved itself after a reboot of the PC. I have no idea what was wrong.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.