Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21615 Discussions

Configuring Cyclone devices using jrunner

Altera_Forum
Honored Contributor II
‎06-02-2011 01:00 PM
1,279 Views

Hi, 

I tried to configure some Altera devices using the Altera jrunner and ByteblasterMV. 

The old Flex is configured OK. 

But it's not so with CycloneII. 

 

Jrunner cannot configure EP2C5Q208 and EP2C5T144 - three standard attempts are made and then "Configuration not successful" is displayed. 

 

If I use the Quartus programmer everything is OK. 

 

Has anybody got a successful experience in configuration of Cyclone devices with the help of the jrunner and the byteblaster? 

 

Regards,  

tduty
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-14-2011 08:36 AM
538 Views

Hi, 

I wish to define the state more exactly. 

During configuration with the help of jrunner (+ByteblasterMV+.cdf+.rbf) when CheckStatus function is fulfilled it returns 0 that is an error. 

Why is it so I cannot quess. 

Maybe anybody can explain it? 

Regards, 

tduty
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.