Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21148 Discussions

Cyclone 10GX Differential termination

dkurgs
Beginner
1,115 Views

Greetings all,

we are designing a PCB including the Cyclone 10GX220 and were slightly confused by the datasheet.
We wish to terminate an incoming LVDS pair using the normal 100 Ohm differential termination (the datasheet calls it RD).
Do we still need to calibrate the OCT? Should we still connect an external OCT calibration resistor to the bank's RZQ pin?

Thanks!

0 Kudos
1 Solution
EngWei_O_Intel
Employee
1,103 Views

Hi Daniels

 

Thanks for your inquiry.

If you have the OCT enabled for the FPGA, you do not need external termination. There is no calibration needed for Rd OCT.

 

Thanks.

Eng Wei

View solution in original post

2 Replies
EngWei_O_Intel
Employee
1,104 Views

Hi Daniels

 

Thanks for your inquiry.

If you have the OCT enabled for the FPGA, you do not need external termination. There is no calibration needed for Rd OCT.

 

Thanks.

Eng Wei

EngWei_O_Intel
Employee
1,046 Views

Hi Daniel

I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

 

Eng Wei

0 Kudos
Reply