Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21588 Discussions

Cyclone IV GX in QFN148

Altera_Forum
Contributeur émérite II
1 938 Visites

Does anybody use this chips? They have unmatched package specification in early and current documentation. There are VCC Bus surrounding GND pad in early docs, but it doesn't exist in current specification.  

This space would be very useful in case of bus absent for via placement, however I can't find Altera recommended footprint and/or layout recomendations for this case. 

I have EP4CGX15BN11C8NES chips - they have such bus. Does this bus absent in mass production devices ? Does anybody have Altera recommended footprint for this device ?
0 Compliments
5 Réponses
Altera_Forum
Contributeur émérite II
1 094 Visites

 

--- Quote Start ---  

Does anybody use this chips? They have unmatched package specification in early and current documentation. There are VCC Bus surrounding GND pad in early docs, but it doesn't exist in current specification.  

This space would be very useful in case of bus absent for via placement, however I can't find Altera recommended footprint and/or layout recomendations for this case. 

I have EP4CGX15BN11C8NES chips - they have such bus. Does this bus absent in mass production devices ? Does anybody have Altera recommended footprint for this device ? 

--- Quote End ---  

 

 

You have EP4CGX15BN11C8Nes chips. These are "Engineering Samples", so You may have special chips that are not released to the market.
0 Compliments
Altera_Forum
Contributeur émérite II
1 094 Visites

 

--- Quote Start ---  

You have EP4CGX15BN11C8Nes chips. These are "Engineering Samples", so You may have special chips that are not released to the market. 

--- Quote End ---  

 

 

I've checked parts again. I was wrong - it's C8N chips (not ..ES). So it isn't special chips.
0 Compliments
Altera_Forum
Contributeur émérite II
1 094 Visites

Then the pinout should be identical to the pinout shown in Pin Planner.

0 Compliments
Altera_Forum
Contributeur émérite II
1 094 Visites

 

--- Quote Start ---  

Then the pinout should be identical to the pinout shown in Pin Planner. 

--- Quote End ---  

 

I don't ask about regular pins (visible in pin planner) - I ask about VCC bus at the bottom of package. Please look at the picture for details.
0 Compliments
Altera_Forum
Contributeur émérite II
1 094 Visites

Did you review the Quartus *.pin file? There should be also pinout Excel and PDF documents.

0 Compliments
Répondre