- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have been using Altera's Cyclone III 3C120 Development Board which has 2 USB PHY devices, one of them is CY7C68013A. The Altera manual reference states that the chip is put in reset and is for future use. I have also tried using 'Ez USB Console' but it did not recognize the device. I would like to ask that how I can access the chip since I need develop simple USB communication between the board and PC without depending on Altera's IP core.
Thank you very muchLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
as far as i know, instructions for using the Cypress USB device are not available
i would probably use an FTDI chip on an HSMC breakout board- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you, thepancake.
I am looking into that rightnow. I think I would use Cypress since Im having a developmentboard for it. Non of the USB device on the Altera's board is easy to use....strange
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page