- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
if i have a single x16 DDR4 component connected to a ARRIA10 device and running at 800 Hz clock(1600 MT\S ) - is there a waiver that allow me to not have a VTT termination for the ADDRESS\CONTROL signals ?
Are you familiar with designs which have done that?
Thanks,
Lior
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You will need to run the Board simulation if you wish not to terminate the ADR/CMD to VTT.

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page