Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20690 Discussions

Duplicate GPIO pins in Pin Planner

Altera_Forum
Honored Contributor II
‎06-12-2018 02:15 PM
1,079 Views

In the Pin Planner, I want to switch physical locations of my pin names. However, everything is in duplicate. I saw a publication of this issue in Quartus II and and read that this issue would not happen in the next version. Here I am in Quartus Prime and it is still happening. Do I just reassign each pair? Please advise.

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-13-2018 12:24 AM
367 Views

Hi, 

Please, provide following details, 

1. Quartus tool Edition & version 

2. Device/Kit used 

3. Duplication screenshot 

 

Best Regards 

Vikas Jathar  

(This message was posted on behalf of Intel Corporation)
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.