How to connect unused GXB_TX pins in an ARRIA GX device

[Altera_Forum]

I am trying to figure out how to terminate unused GXB_TXp and GXB_TXn pins in an Arria V GX device. 

  Thanks, Dan

[Altera_Forum]

Dan - 

 Have you read the Arria V pin connection guidelines?  https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/dp/arria-v/pcg-01013.pdf  This is a very important document for all families. It says to leave all unused GXB_TX pins floating. No need to terminate.  Bob

[Altera_Forum]

--- Quote Start ---  Dan -  Have you read the Arria V pin connection guidelines?  https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/dp/arria-v/pcg-01013.pdf  This is a very important document for all families. It says to leave all unused GXB_TX pins floating. No need to terminate.  Bob  --- Quote End ---    Thank you for the response. Yes, I did read that document.  It says "Leave all unused GXB_TXp pins floating", which seems to inply to float just the "p" pins. Hence my confusion.   Dan

[Altera_Forum]

--- Quote Start ---  Thank you for the response. Yes, I did read that document.  It says "Leave all unused GXB_TXp pins floating", which seems to inply to float just the "p" pins. Hence my confusion.   Dan  --- Quote End ---    I see what you mean. It's a typo. Leave both pins floating. You should let Altera know about this. Check the PCG for Cyclone V, Arria 10, etc. They correctly say to leave both pins floating.  Bob