How to setting fast sim mode for P TILE PCIe simuation

[yu1987-08-22]

Hi,

 use quartus 22.4 and device : Agilex AGFB027R25A2E3E, Generated example design, PCIe setting as following picture:

and running the vcs(P-2019.06-SP2-10) simualtion, link up need about 145us.

This is slowly for simulation, can you help me how to setting fast sim mode? Thanks so much.

[Wincent_Altera]

Hi,

FastSim mode is currently not supported for the P-Tile architecture in the Intel Agilex family of FPGAs.

Therefore, it's not possible to apply FastSim mode to designs targeting P-Tile devices in Intel Quartus Prime software.

Hope this answered your question.

Regards,

Wincent_Intel

[yu1987-08-22]

Hi ,

 That's crazy for simulation.  Is support PIPE Mode?

Thanks

[Wincent_Altera]

Hi,

Please accept my apology for the inconvenience cause.

As far as now the fastsim mode only support f-tile.

Regards,

Wincent_Intel

[yu1987-08-22]

Hi,

  Thank you so much.

[yu1987-08-22]

Hi ,

 I got your mail, but for simulation its so slowly, if don't have method to fast simulation, we only can receive that.

Thank you for helping me confirm that.

[Wincent_Altera]

Hi,

Thanks for your understanding. With that said I am setting this as close on my place.

If you have a new question, feel free to open a new thread to get support from Intel experts.

Otherwise, the community users will continue to help you on this thread. Thank you

If you feel your support experience was less than a 9 or 10,

please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.

Regards,

Wincent_Intel