Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

How to write data from PC to Flash memory (not using de0 control panel)

Altera_Forum
Honored Contributor II
‎01-26-2014 12:34 PM
1,410 Views

Any insight on the title problem is greatly appreciated. 

 

I want to load data (e.g. image data) from PC into the memory and then later use that memory when I initiate start signal.
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎01-26-2014 03:14 PM
713 Views

So it seems to me I have to make a UART controller in the FPGA?

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎01-27-2014 01:21 PM
713 Views

On the DE0 if you put a Serial Flash Loader or a Parallel Flash Loader image in the FPGA you can directly access the EPCS flash from Quartus Programmer.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.