CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
I have strange problem: i open programmer in Qartus 7 but it's dont recognize my Jtag cabel/ it's write "no hardware"/ I tried program FLEX10K from MAXPLUS programer ant it's work/ plese help to solve this problem!!!!
"no hardware" means, that the ByteBlaster II hasn't been selected (respectively not yet installed) in programmer hardware setup. If ByteBlaster is selected but not recognized, the message is "hardware not connected".
wow I so donkey!!! i have done it 20 times today/ i opened Hadware setup->
add hadware->choose Byteblaster. but only one i haven't done - to choose in curently celected hadware --byteblaster/ thanks for you !!! I'm going to work ill to morning
