- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
I am new to Altera FPGA boards and sofware tools. I have used Xilinx tools. I have Arria V SoC development kit. I want to interface my custom hardware to ARM and call the hardware in C language in both bare metal and Linux environments. I have documents on Rocketboards.org and documents provided by Altera. But many of these documents use template designs without explaining step by step process. Also these documents use shell commands that hides on going steps. Please reply how should I start and learn. If there are any documents or tutorials which provide step by step processes, that will be very helpful for me. The documents need not to be explicitly meant for Arria V SoC kit. Documents for any development board will do. My requirement: I want to learn the flow ​and interface a custom hardware to ARM and call it in C language. I want to use DS-5 tool. Thank you all in advance.Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check out these online trainings to get started:
https://www.altera.com/support/training/catalog.html?coursetype=online&language=english&keywords=arm- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the reply.
Both the training courses are very much useful. They have clarified many of my doubts. Thanks a ton! I will follow the courses in more detail and share my experience. Once again thank you! Regards
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page