Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21615 Discussions

PCB Design on MAXII device (EPM1270) with CADSTAR

Altera_Forum
Honored Contributor II
‎03-04-2008 12:10 PM
1,274 Views

Hi, 

I'm a student as well as a beginner doing a project on MAXII Starter Kit Demo Board ( http://www.gfec.com.tw/pro_flypage.php?language_page=english&class1_seria l=1&class2_serial=&class3_serial=&p_serial=11 ). I was told to design the PCB with the given Schematic from the user guide .pdf file. However, I have encountered some problems like how to get the MAXII device and 8051 Mircoprocessor symbols from the libary as i couldn't find anything from the CADSTAR libary. Is there any professional or experts have the solution to this ? 

 

Thank you 

Regards, 

Kio :)
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎03-06-2008 09:42 AM
563 Views

Just design your own parts, it should only take a few minutes. 

 

Leon
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.