Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21336 Discussions

Power to the transceiver block in Arria II device

Altera_Forum
Honored Contributor II
‎01-04-2011 06:30 AM
959 Views

Hi, 

 

I am using Arria II device and I am not using Transceiver block on my board. Is it necessary to give power to the transceiver blocks even when I am not using it. 

 

Thanks in Advance
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-04-2011 05:07 PM
289 Views

you should take a look at the Pin Connection Guidelines and the Schematic Review Worksheets: 

 

http://www.altera.com/literature/lit-dpcg.jsp 

 

http://www.altera.com/download/board-layout-test/schematic-review-ws/srw-index.jsp
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.