Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Problem JTAG chain detection with Byteblaster II

Altera_Forum
Honored Contributor II
‎12-13-2010 04:35 PM
1,100 Views

Hello, 

 

I'd like to install a byteblaster II on a PC Windows XP. 

I updated MaxPlusII to version 10.22. 

The byteblaster is connected via a extension cord to a parallel port LPT1.  

The byteblaster is detected by Maxplus II, no problem. 

But when I want to check the JTAG chain, the message shows 0 device detected instead of 3. 

I tried with another card, but it is the same thing. 

 

Precisions: under BIOS, LPT1 is on EPP mode. 

address: @378 

The drivers are pgdhdlc.sys (4.0) and pgdhdlc.dll(3.51). 

I tried also the bblpt.exe.... 

With regedit, the byteblaster service is parport.. 

 

Thanks a lot for your help !! 

Sandra
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.