Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Program the 10M25DA CPLD using command line or batch file. Is there an example?

HVald
Beginner
‎02-14-2019 12:34 PM
1,819 Views

Currently using the Quartus Prime Programmer Lite Edition to program 10M25DA CPLD. I would like to bypass GUI.

0 Kudos

Link Copied

2 Replies
ShafiqY_Intel
Employee
‎02-15-2019 09:19 AM
1,383 Views
Hi, You may refer to the link below for more understanding about quartus_pgm (on page 76) https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/manual/tclscriptrefmnl.pdf#page=76 You may also refer to the discussion below for example. https://forums.intel.com/s/question/0D50P00003yyGH4SAM/quartus-ii-programmer-command-line Thanks.
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.