- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I'm using Altera max 10 @10M50DAF484C6GES,
I would like to interface an IC along with QSPI I can figure out the pins connected to the FPGA but i can't able to figure it out where the remaining pins exposed kindly help me with it .
Regards
Tex
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tex,
Kindly please refer to page 63 of the Flash section in the MAX 10 FPGA Development Kit User Guide.
Regards,
Fakhrul
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tex,
Kindly please refer to page 63 of the Flash section in the MAX 10 FPGA Development Kit User Guide.
Regards,
Fakhrul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply,
apologies for the misconvenience i've checked the user guide and i can be able to check the pin numbers,
but where the pins got exposed where can i external able to access the qspi pins
regards,
Tex
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page