- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Intel FPGA support team,
We have selected Cyclone V GX and we are going to use MT25QL QSPI flash device as configuration flash. We wanted to ensure about the pin connectivity from the FPGA device to the QSPI flash. Kindly check the attached schematic diagrams and let us know whether any changes are required. Also had the doubt on RESET# pin of MT25QL device connectivity to FPGA. Which pin of FPGA needs to be connected to MT25QL QSPI Reset# pin? Please provide the inputs.
Thanks and regards,
Nagendra
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for contacting Intel community.
Based on my understanding, you have queries in Micron flash support for Cyclone V FPGA.
You may refer to https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-gen-sfi.pdf on interfacing with Micron flash.
Please refer to below link for pin connection guidelines.
https://www.intel.la/content/dam/www/programmable/us/en/pdfs/literature/dp/cyclone-v/pcg-01014.pdf
Regards,
Aiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page