Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
20577 Discussions

STRATIX 10 JTAG Configure problem

hzhan133
Beginner
406 Views

Device: Stratix 10 ​1SX280HH3F55E2VG

SOFTWARE: Quartus 19.1

Encounter a configuration problem, as follows:

Can identify the JTAG chain, where FPGA0 can download the sof file normally, FPGA1 fails to download the sof file, stuck at 2%

The prompt is as follows: (specifically as shown in the figure below)

Error (18950): Device has stopped receiving configuration data

Error (18947): Device not responding

Error (209012): Operation failed

At present, only one of the several boards has such a problem.

Tried changing MSEL to JTAG ONLY mode has no effect.

May I ask what may be the cause.

 

S10_CFG.png

0 Kudos
3 Replies
YuanLi_S_Intel
Employee
343 Views

Hi,

 

May i know what USB Blaster you are using? II or I? Can you change the TCK frequency to 6MHz and try again?

 

Thank You

0 Kudos
hzhan133
Beginner
343 Views

USB Blaster I.

It is difficult to determine the specific error from the error message. Please try these two methods first:

1. Quartus project do not bring GXB, DDR, or EMIF, only do the simplest lighting project

A: The error has changed. The prompt may be a PMBUS configuration problem, but this SOF configuration file is OK on other boards or different FPGAs of the same board. For details, please refer to the attachment

S10_CFG1.png

0 Kudos
YuanLi_S_Intel
Employee
343 Views

The error means that the VID setting is not correct for the device. Can you take a look at our Stratix 10 power user guide? You will need to follow the setting available in it.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/stratix-10/ug-s10-pwr.pdf (Page 26)

0 Kudos
Reply