Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

STRATIX II fpga is not getting initialized

Altera_Forum
Honored Contributor II
‎02-11-2008 11:18 AM
1,499 Views

We are trying to confugure stratix II fpga(EP2S90H484C4) in JTAG mode. The config done pin is going high but init_done pin is not going high. The init_done pin is enabled in quartusII software and a pullup is also connected to the init_done pin. The init done pin goes low once the configuration starts but it is never becoming high later. There is not output from the fpga. what could be the problem in this case. Have anybody faced such a problem. 

 

Thanks in advance, 

Suvedha
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎02-13-2008 09:49 AM
628 Views

Is conf_done pulsing, or is it constantly high?

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.