Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Side selection issue

Altera_Forum
Honored Contributor II
‎06-07-2010 10:27 AM
1,025 Views

Hi, All 

 

Our design is going to use 2 Sides of EP3C40, Because there are not enough DQ pins in 1 Side. For better performance, which two should chose?  

TOP and Bottom or Bottom and Right, or Others, and Why? 

 

Thanks
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.