- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi I did a simple transceiver project in Qys running at 1250Mbps. I have generated the Verilog code for the design and programmed the device. However, I have trouble establishing a link in the system console to run the BER and EyeQ analysis. The FPGA used is 5SGXEA7N2F45C2ES and version of Quartus is 12.0. Attached are some pictures related to the project. Would really appreciate it if anyone could help me figure out what is wrong. Thanks.
Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page