Unable to program Remote System Upgrade over UART based on NiosII Processor with EPCQ(cyclonev dev )

[manishkumar]

unable to program:

Remote System Upgrade over UART based on Nios
II Processor with EPCQ (Cyclone V E FPGA
Development Kit) design example to CycloneV E FPGA Dev kit.

shown errors while programming files through Quartus prime programmer: Can't recognize silicon id for device1. A device's silicon ID is different from its JTAG ID: VERIFY THAT ALL CABLES ARE SECURELY CONNECTED

[Farabi]

Hello,

Can you refer to this reference design?

link : https://www.intel.com/content/dam/support/us/en/programmable/support-resources/fpga-wiki/asset03/nios-ii-processor-booting-from-cfi-flash.pdf

regards,

Farabi

[Farabi]

Hello,

Please also refer to this link : https://www.intel.com/content/www/us/en/support/programmable/support-resources/design-examples/horizontal/system-upgrade-over-uart-nios-ii.html

regards,

Farabi

[Farabi]

Hello,

I have provided you the answer, I will transfer this case to community. If you have another question, please raise new forum case we will be happy to help.

regards,

Farabi