- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm an FPGA green hand. I wanna use the Arria GX development board to generate 3 singals to control the movement of a probe. I don't know how can I do this, and how can I connect the signals to the target? since I didn't find any output ports on the board. :confused:
Hope I can get some useful help. Thanks!Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have to use a daughter board of type GPIO-HSMC, like this: http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=67&no=218
Thus you can access the IOs of HSMC connector of Arria Gx kit.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much!
Can I connect the AD/DA data conversion card to the arria gx devlopment board?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes. It's possible.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page