cannot add target device when in current programming mode

[sassonvn]

Hi,

After compilation and generation of .pof file based on my flash (MT25QV256),

I'm trying to add it to the programmer and burn it through JTAG, but get the error: 
"Cannot add target device MT25QL256 to device chain when in current programming mode.

the FPGA is cyclone V.

any suggetions?

Thanks,
Sasson

[NurAiman_M_Intel]

Hi,

If it is in JTAG, can you change it to Active Serial Programming then try to insert the .pof file again?

Regards,

Aiman

[sassonvn]

Hi Aiman,

Thanks for your reply.

When trying to do so, it's working.

But I need the JTAG mode.

thanks,
Sasson

[NurAiman_M_Intel]

Hi,

You will need to generate .jic or .sof to used with JTAG.

Regards,

Aiman

[NurAiman_M_Intel]

We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you