Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

display net names

Altera_Forum
Honored Contributor II
‎10-28-2015 08:28 PM
2,089 Views

I can not seem to figure out how to determine the name of a net on a schematic. I tried properties and all get is font settings. I get error messages that refer to a net but can not find the net

0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎10-28-2015 08:54 PM
789 Views

Been a while, but can you right-click Locate on the error and it highlights the net?

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎10-28-2015 09:03 PM
789 Views

 

--- Quote Start ---  

Been a while, but can you right-click Locate on the error and it highlights the net? 

--- Quote End ---  

 

 

when I click on the error it takes me to the device. This is good. But all i want to see is the net names. I found an obscure post that indicated that there was an option 

menu somewhere where you simply set an option to have net names displayed on the schematic. But I can not find the display option panel.
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.