Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20688 Discussions

flash memory issue

Altera_Forum
Honored Contributor II
‎10-05-2016 01:23 PM
897 Views

Hello everyone,  

I have a Altera max10 

I have a flash memory issue. When I download a program in FPGA, then I power off then power on. The program isn't keep in memory. 

I use the same software, but with a kit max10. The memory works. So that's mean I have a hardware issue. But when I check some pins like  

-CONF_DONE. It has a pull up, so no problem. 

-nSTATUS should be connect to a pull up. But it's put in a ground. But normally no impact. 

So Except CONF_DONE nSTATUS nConfig. What else pins should I verify? 

Thanks a lot
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.