- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How can I tell Quartus that I want to use nCEO on my Cyclone III device as an I/O?
I get an error when I compile: Error: Can't place multiple pins assigned to pin location Pin_101 (IOPAD_X41_Y19_N14) Info: Pin muxbus[2] is assigned to pin location Pin_101 (IOPAD_X41_Y19_N14) Info: Pin ~ALTERA_nCEO~ is assigned to pin location Pin_101 (IOPAD_X41_Y19_N14)Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
go to Assignments > Device > Device and Pin Options > Dual-Purpose Pins
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks! I keep losing track of that dialog, it's located a bit deep in the GUI.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page