I have some problems when using the board card according to the manual of Intel FPGA Programmable Acceleration Card N3000 .
I hope to get the answers here.
In chapter 9, Section 2, on page 51, when I had installed PKtgen-3.7.1 and followed the relevant commands to receive and dispatch packages, it was not like the results shown in Picture 22.
In my experiment, no packets were sent.
Can you provide some logs showing each step that you have taken and what are the outputs.
There is also the INSTALL.md instructions that you must follow on top of what the doc has.
For the hardware, did you connect a cable across both the QSFP?