Software Archive
Read-only legacy content
17061 Discussions

About using command line for Intel Parallel Inspect and Intel Parallel Amplifier

Peter_W_Intel
Employee
‎09-26-2009 08:09 PM
457 Views
Actuallythe userdoesn't need to start upGUI again, that Intel Parallel Inspector Update 1 and Intel Parallel Amplifier Update 1 have implemented thesecool functions.

If have interests, please read:
http://software.intel.com/en-us/articles/use-command-line-in-intelr-parallel-inspector/
http://software.intel.com/en-us/articles/use-command-line-in-intelr-paralle-amplifier/

0 Kudos

Link Copied

1 Reply
KitturGanesh
Employee
‎09-28-2009 09:50 AM
457 Views

Thanks for the post Peter. I was about to addone onthe availability of the command line interface ijn update1 release of the Amplifier/Inspector since I was asked offline from another forum user on such availability.

-regards,
Kittur
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.