- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I could not find a forum for the Binary Configuration Tool. I am using the BCT to configure the FSP binary for a Baytrail Atom E3815 processor. The BCT allows you to enable either or both of the HSUART ports. If they are enabled, does the binary completely configure the registers? If so, what is the base address for these devices?
BAR0 for Bus 0 Device 30 Function 3 and
BAR0 for Bus 0 Device 30 Function 4
- Tags:
- Firmware
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
BCT isn't supported on this forum, or on IDZ in general. This is associated with Intel FSP, so please check this site for information: http://www.intel.com/content/www/us/en/intelligent-systems/intel-firmware-support-package/intel-fsp-overview.html
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Going to that link and trying to get support brings me right back here!!!!!!!!!!!!!!!!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page