- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
On previous, I have been used Visual Studio 2008 with Intel visual fortran 11.1.3463.2008 and move to Visual Studio 2013 and Intel Parallel Studio XE 2015 Composer edition for fortran windows on my 64 bit windows 7 computer. My problem is that in the debug mode the program doesn't move step by step as i shown on the figure and some time does not show the values of the variables.
Run To Cursor at the first step :
After use F10 or Step Over ( one time ) then move to third step :
Thanks for your help in advance.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For more information Intel Parallel Studio XE 2015 Composer 15.0.0107.12
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
could you please let me know whether optimizations were turned off (/Od)?
I expect "non linear" stepping with any optimization turned on, but not if no optimization was done. In case it is reproducible with optimizations turned off, I'd like to ask you for a small example project. For that case it might be related to the debug information which we should track down.
Thank you & best regards,
Georg Zitzlsberger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page