Help,i can't compile my sketch with Aurdion IDE for edison board

chen_c_1 · ‎03-18-2015

The IDE i downloaded was built in 1.6.0: http://www.intel.com/support/edison/sb/CS-035180.htm, I installed the mac os X version(my system:os x 10.10). When i choose the "intel edison" from the board options(the other X86 options are the same), and press the verify button, the following appers, i wonder how to solve it ? Thank u all

Matthias_H_Intel · ‎03-19-2015

maybe something went wrong when extracting the tarball?
where did you install? maybe the overall path length is too long?
is the "as" executable actually set as executable? (check ls -la on that file)

Apparently you double-posted in https://communities.intel.com/thread/61553. I'd suggest to continue on this thread and close the other one

chen_c_1 · ‎03-19-2015

matthias-hahn (Intel) wrote:

maybe something went wrong when extracting the tarball?

where did you install? maybe the overall path length is too long?

is the "as" executable actually set as executable? (check ls -la on that file)

Apparently you double-posted in https://communities.intel.com/thread/61553. I'd suggest to continue on this thread and close the other one

thanks for ur reply

i download it again & extract it properly, seems nothing goes wrong . and I put the app into my application folder as the guide told , so i don't think the path would be too long to cause the problem. I am sorry that i can't understand the point u mentioned at last since i am just a novice^.^, but that file only contains 2 empty functions:setup()&loop(), doing nothing at all.

thanks again for reminding double-posted

Matthias_H_Intel · ‎03-19-2015

chen c. wrote:

i download it again & extract it properly, seems nothing goes wrong . and I put the app into my application folder as the guide told , so i don't think the path would be too long to cause the problem. I am sorry that i can't understand the point u mentioned at last since i am just a novice^.^, but that file only contains 2 empty functions:setup()&loop(), doing nothing at all.

thanks again for reminding double-posted

ok. Thanks for downloading again and checking the paths. On the 3rd bullet of my list. Your output shows that /as can't be executed. Can you check "ls -la /as" whether the execution flag is set?