Software Archive
Read-only legacy content
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17060 Discussions

Intel Parallel Inspector

mg
Beginner
844 Views
Hi,

When I try to launch Inspector using an exe that I know is a executable binary - I get this error message:

Cannot Start Analysis

File "....exe" is not an executable binary.

The exe run fine both in debug/no debug mode.

Any ideas?

Regards,
Morten
0 Kudos
5 Replies
Vladimir_T_Intel
Moderator
844 Views
Hi Morten,


Please, give us some more information:

  • Which OS (32-bit or 64-bit)?
  • Which Inspector build number?
  • Which type of analysis?
  • Do any other executables work fine with Inspector?

0 Kudos
Vladimir_T_Intel
Moderator
844 Views
One more question needs to be clarified. Is that project/exe located on the shared drive (mapped or linked)?

0 Kudos
mg
Beginner
844 Views
Hi Morten,


Please, give us some more information:

  • Which OS (32-bit or 64-bit)?
  • Which Inspector build number?
  • Which type of analysis?
  • Do any other executables work fine with Inspector?


- XP 32 bit OS
- Evaluation copy (downloaded on May 26, 2009) - cannot find any build number
- Analysis type: Threading errors
- Tried the tutorial sample (banner) - seems to work fine
- Every thing (project, exe, MVS2008 and Inspector) are located on the local drives
0 Kudos
rajureddyibpyahoo_co
844 Views
0 Kudos
rajureddyibpyahoo_co
844 Views
Quoting - mg
Hi,

When I try to launch Inspector using an exe that I know is a executable binary - I get this error message:

Cannot Start Analysis

File "....exe" is not an executable binary.

The exe run fine both in debug/no debug mode.

Any ideas?

Regards,
Morten

0 Kudos
Reply