Software Archive
Read-only legacy content
17061 Discussions

Mapping Audio to I2c

Darren_S_1
Beginner
‎03-14-2017 12:26 PM
381 Views

I have an Edison with a DFRobot board that has i2C on the board.  I have connected an Adafruit Stereo 2.8W Class D Audio Amplifier - I2C Control AGC - TPA2016.  I can see the device on i2cdetect -l 6 address range 0x03-0x77.  I would like to map audio playback to this device rather than using either BT or USB.  I am on Yocto 3.10.17-poky-edison+

I would hope that I could edit a config file to tell the system that playback should go through i2c.  Any help would be appreciated.

0 Kudos

Link Copied

1 Reply
Harold_G_Intel
Employee
‎03-14-2017 01:00 PM
381 Views

Hi Darren,

The Intel(R) Edison module is supported in communities.  You may want to repost this here:  https://communities.intel.com/community/tech/edison

Regards, Hal

Intel(R) Developer Zone Support

http://software.intel.com
*Other names and brands may be claimed as the property of other

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.