- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, trying to use MSDU aggregation wireless transfer between AP and 6300 adapter, however, when i use sniffer to capture the ADDBA response from 6300 to AP, it shows in the 802.11 management - action section of the captured packet that MSDU not permitted (value is 0)
driver version: 15.2.0.9
when forcing MSDU aggregation transfer between the devices, it shows that 6300 supports MSDU.
I'd like to know why in my sniffer (omnipeek wild packet) output shows it's not permitted but i was able to transfer MSDU aggregated frames between the 2 devices, is it due to Intel(R) driver issue? or omnipeek issue?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sage99,
Thank you for your post. Please take in to consideration that these adapters are designed to not support Promiscuous mode therefore getting strange results, while doing packet analysis would be expected.
We are sorry for any inconveniences this may cause.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Mark, based on your experience, do you also encounter the same strange result?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page