Embedded Connectivity
Intel network controllers, Firmware and drivers.

About unused pins of I210-AT

kzk6700
Novice
315 Views

I am currently designing a design and am considering replacing it with I211-AT to I210-AT.

 

The following pins have different functions between I211-AT and I210-AT.

No. 34 RSVD34_PU (I211-AT)  ---> SMB_CLK (I210-AT)

No. 35 RSVD35_PU (I211-AT)  ---> SMB_ALRT_N (I210-AT)

No. 36 RSVD36_PU (I211-AT)  ---> SMB_DAT (I210-AT)


The current design is all Pull-Up (VCC3p3, 10k-Ohms), but is it okay to connect as it is?
Or is it better to remove the Pull-Up?

 

0 Kudos
1 Solution
CarlosAM_INTEL
Moderator
299 Views

Hello, @kzk6700:

Thank you for contacting Intel Embedded Community.

We sent an email to the address associated with this account with suggestions that may help you.

Best regards,

@CarlosAM_INTEL.

View solution in original post

1 Reply
CarlosAM_INTEL
Moderator
300 Views

Hello, @kzk6700:

Thank you for contacting Intel Embedded Community.

We sent an email to the address associated with this account with suggestions that may help you.

Best regards,

@CarlosAM_INTEL.

Reply