I226-IT 10M/100M/1G/2.5G Test Patterns on AGX Orin

[LeoZe]

Hi Intel Team,

How can I configure Ethernet Compliance Tests (10M/100M/1G/2.5G) for I226-IT

on Jetson AGX Orin?

We have referenced documentation #615722 from Intel RDC, but it can't be executed

directly on the aarch64 platform.

Is it possible to configure it through writing to registers like Intel I210?

Best regards,

Leo

[LeoZe]

Is there any update?

[Diego_INTEL]

Hello @LeoZe,

Thank you for contacting Intel Embedded Community.

I have sent an email to the address associated to your account.

Best regards,

@Diego_INTEL 

[GuowenYu]

Hello Diego.

Ask the same question, please share.

Thanks a lot!

Best Wishes!

Guowen.Yu

[Diego_INTEL]

Hello @GuowenYu,

Thank you for contacting Intel Embedded Community.

Of course, I have sent an email to the address associated to your account, I hope this information may be of help.

Best regards,

@Diego_INTEL 

[chia]

Hello Diego.

The same question , need your help , please share.

Thanks a lot!

Do commandl line only supported ??

[Diego_INTEL]

Hello @chia,

Thank you for contacting Intel Embedded Community.

At that time, I was recommending a document that may help to compliance test for the i225/i226 in ARM, but ARM is not supported for these controllers, for ARM we have the EEPROM Access Tool [EAT], that can help to perform some basic functions.

Actually, it will be necessary that you create an IPS ticket for further help regarding this topic.

https://www.intel.com/content/www/us/en/support/articles/000057045/ethernet-products.html

Best regards,

@Diego_INTEL