- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to enable ECC on a derivative E3845 PCB using the BCT/coreboot solution for the firmware. It works for the most part, but I am not seeing any indication that ECC is enabled. Do I need to change any settings in BCT other than "Bakersport-ECC" and/or "DDR3ECC"? Do I need to enable CH1?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello drice,
Thank you for contacting the Intel Embedded Community.
The information that may help you is stated in the note of the step 4.a in section 5.0; on page 13 of the http://www.intel.com/content/dam/www/public/us/en/documents/guides/atom-e3800-crb-guide.pdf Intel(R) Atom(TM) Processor E3800 Product Family Customer Reference Board (CRB) Platform Guide.
It is important to let you know that the Coreboot consultations should be further answered through the emails listed at the http://www.coreboot.org/mailman/listinfo/coreboot coreboot Info Page.
Please let us know if this information is useful to you.
Best Regards,
Carlos_A.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page